The WP worm gear reducer is developed on the basis of the WD reducer. The worm is made of 45# high-quality steel and processed by heat treatment. The worm wheel is made of tin bronze with good wear resistance, especially in terms of load capacity. Worm gear reducer is mainly suitable for the reduction drive of various mechanical equipment such as plastics, metallurgy, beverage, mining, lifting and transportation, chemical construction, etc.
| Working conditions： | 1、The worm speed of the worm gear reducer cannot exceed 1500r/min.
2、The working environment temperature is -40℃-+40℃. When the working environment temperature is lower than 0℃, the lubricating oil must be heated to above 0℃ before starting. When the working environment temperature is higher than 40℃, cooling measures must be taken.
3、The shaft of the worm gear reducer can rotate forward and backward. | | | Precautions： | 1、Worm gear shafts must not be used as input shafts.
2、The matching motor (ie power) cannot exceed the value specified on the label.
3、If the user wants to change the direction of the shaft, the second end cover of the shaft can be disassembled, the worm shaft can be taken out, and the shaft can be adjusted 180. Just load it. Do not knock hard when installing, but slowly drive the two shafts to engage them.
| Performance characteristics： | 1、Smooth transmission, low vibration, impact and noise, large reduction ratio, wide versatility, and can be used with various mechanical equipment.
2、A large transmission ratio can be obtained with a single-stage transmission, and the structure is compact. Most types of reducers have better self-locking performance, and can save braking devices for mechanical equipment with braking requirements
3、The meshing friction loss between the worm thread and the tooth surface of the worm gear is large, so the transmission efficiency is lower than that of the gear, and it is easy to generate heat and higher temperature.
4、Higher requirements for lubrication and cooling.
5、Good interoperability, worm gears and worms are manufactured according to national standards, and standard parts such as bearings and oil seals are used.
6、The cabinet type has basic type (the cabinet is a vertical or horizontal structure with a foot plate) and a universal type (the cabinet is a rectangular parallelepiped, with fixed screw holes on multiple sides, without foot plates or additional foot plates, etc. Various structure types)
7、There are two types of input shaft connection: basic type (single input shaft and double input shaft) and with motor flange.
8、The position directions of the output and input shafts have the input shaft down and up; the output axis up and down; the input axis up and down.
9、Two or three reducers can be used to form a multi-stage reducer to obtain a great transmission ratio. |
|
|